Subject: Re: Can't get DVD to use DMA
From: Justin Dieters (enderak@gci.net)
Date: Tue Oct 14 2003 - 22:43:24 AKDT
As a follow-up to my message, these are the IDE-related lines I get when
I boot up. It all looks normal to my untrained eye...
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 89
PCI: No IRQ known for interrupt pin A of device 00:11.1. Please try
using pci=biosirq.
VP_IDE: chipset revision 6
VP_IDE: not 100%% native mode: will probe irqs later
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: VIA vt8233a (rev 00) IDE UDMA133 controller on pci00:11.1
ide0: BM-DMA at 0xb400-0xb407, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xb408-0xb40f, BIOS settings: hdc:DMA, hdd:DMA
hda: WDC WD400BB-00DEA0, ATA DISK drive
hdb: WDC WD400BB-00DEA0, ATA DISK drive
hdc: PLEXTOR CD-R PX-W4012A, ATAPI CD/DVD-ROM drive
hdd: JLMS XJ-HD163D, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 78165360 sectors (40021 MB) w/2048KiB Cache, CHS=4865/255/63, UDMA(100)
hdb: 78165360 sectors (40021 MB) w/2048KiB Cache, CHS=4865/255/63, UDMA(100)
Justin
---------
To unsubscribe, send email to <aklug-request@aklug.org>
with 'unsubscribe' in the message body.
This archive was generated by hypermail 2a23 : Tue Oct 14 2003 - 22:47:30 AKDT